A multimeter is a handy tool when used correctly... but do you really know how to use one? If you don’t then this article can help to bring you up to snuff in no time flat. The device is explained in ... more

Making of a modding power supply. I’ve dreamt for quite some time now to get a decent laboratory power source. Now that I’ve made a few of these mods, my needs have been mainly two voltages: +5 and +12 ... more

Wolfman: Most mobos have some kind of hardware monitoring softwares included in the installation CD. These softwares are used to monitor your mobo and CPU temperature, and sometimes your case temperatures, ...

I was using EL wire to light the front of my case then after a few months it got so dim you couldn’t tell it was even on so I went looking for something that will last a long time and something original. ... more

Choosing the right PSU for your modded system can sometimes be a challenge, but the information contained within this Modding 101 should help make choosing the right PSU for your PC a little easier.

Want to know what resistor to use with some led? Take this calculator for a spin and see how it goes.

Wolfman: So you’ve just hacked your casing so you can install fans to improve it’s airflow and help cool down your overclocked PC. Your system now runs cooler but you’re getting a headache from all the ...

How many times have you sat next to your computer doing work but couldn’t concentrate because the roaring of your 4 80mm Panaflo’s? Or how many times were you just too tired to get out of bed to turn ... more

The LED meter is a rare mod that is used by only the most daring (read: can kill a parallel port) or well funded case modders. This mod uses the printer port to transmit data to an array of 8 LEDs, making ... more